The new CBD-750CM features an all-new EZ-8 control software and EZ-2 brushless motors. It's perfect for the beginner or those looking for a more powerful machine. It features an upgrade from EasyLite's EZ-7 series classics. This series was designed to mimic the production power of the Easy Cut Studio Essentials and Ultima models at their lowest price point. There is a new Super Easy-Cut 2 software and Cassette with two additional updates since 2016 Easy-Cut Studio Essentials and Ultima.
Other than using easy concrete, it's best to use a base, guide and plunge for best results. At 100% depth, rig the bench with two plates (nailed flush on edge, pin in middle), two thirds-long pieces of base board (between 60-75mm), and half a sheet of plywood (between 15-25mm). The top part of your bench (table top) and the back part (structure), should be two pieces of plywood (15-20mm). Foam pad (at least 30mm) should be added to support your surface when working.
Using the Vinyl vs Acrylic sticker sheet that came with your Easy Cut Studio kit, apply a complete coating of acrylic emulsion resin (Paint-It-All works great). Carefully cut out the most potent parts of your vinyl (the shadows, and the most important parts) and set aside.
You also do not want your vinyl separator and backing (backing plate) to dry out. Apply a complete coating of acrylic emulsion resin to it, let the vinyl sit overnight, and then cut out the backing plate and set it aside.
We're down to it! Once your base plate and backing plate are cut out, it's time to sand and smooth the surface of your project with 220, 400 and 1000 grit sandpaper. Be careful when sanding. For good results, sand both sides of the project, perfecting the bottom first and the top later.
The current circuits all take 20 sq. feet or more of wall space to maximize light output and throw, as they require two DC power supplies. And the only power supplies we have tried included plugging in the two (2) constant voltage power supplies (100-240 VDC) that the DC-120amp household power supply turns into DC-48 volts. To maximize light output and throw, we designed each fixture to run on dual independent power supplies, that allow you to change the power to any specific driver. This allows us to maximize light output and throw d2c66b5586